Du verwendest einen veralteten Browser. Es ist möglich, dass diese oder andere Websites nicht korrekt angezeigt werden. Du solltest ein Upgrade durchführen oder einen alternativen Browser verwenden.
Diskutiere Fehler e19 No zero crossing im ..:: Xelsis SUP- und HD-Modelle ::.. Forum im Bereich *** SAECO / Philips ***; Hello, I have one Saeco Xelsis with error E19. What can I do to repair electric power board to rezolv this error E19.
which error code does it show, look in diagnostic mode the error counter and error text.
is there anywhere water or steam coming out somewhere?
often it is the ribbon cable which has no contact on one ore more pins.
but you are here in the wrong sub-forum !!!
please make a new thread in xelsis forum, left top choose forum, then down to xelsis and right top "Neues Thema erstellen".
Fehler e19 No zero crossing Beitrag #3
hmilbradt
Super-Mod
Dabei seit
03.01.2005
Beiträge
27.150
Hi,
the microprocessor complains about a missing 'zero crossing signal' of the mains voltage. On the PCB is a special circuit that attenuates the 230 VAC sine wave to 5 Volts and converts it either to a square wave or to needle pulses to indicate the zero crossing points. Accurate zero crossing signals a needed by the microprocessor to fire the triacs at the correct time.