Removing Dichtung Vienna Brühgruppe

[haguedick]

Hello,

I can't remove this nylon plastic part in order to clean and replace Dichtung in Vienna Brühgruppe.
I have tried but it seems to be hard.
Could you tell me if it is possible?

Thanks
Dom

 

[Gast13026]

Hello Dom!

Dont remove the Plastikpart. Only the Seal in it. With an stub point needle.

 

[haguedick]

Hello Christian,

As it was hard, i had only removed Dichtung and place a new one with few silicon.
I have another question about Dichtungen :
- When I removed them from Einlaufstutzen and Randelspannmutter they was identicals.

So I wonder on the picture send: Is it right?
Because dichung for Randelspannmutter seems small.

Thanks

 

[Gast13026]

Hello!

You are right. There is something wrong. I have to talk to Ömer Yaman send me the complete Sets. Think the small ring ist for Brewing-Unit Magic-Type at the Tube of Coffeeoutlett

 

[haguedick]

Hello!

Ok, I understand that the picture is good but: the 2 Dichtungen have to be identicals, or not?
Because those I have received are not identical, so I wonder if I can place the small on Randelspannmutter.
I have tried but now Randelspannmutter is very...free.

Regards

 

[Gast13026]

Hello!
I think the Seal for Rändelspannmutter an for Einlaufstutzen should be the same.
I have to clear this with Ömer Yaman tomorow.

 

[haguedick]

Hello,

There is no hurry, it's week end !

Bye
Dom