Saeco Vienna Problem !

[vincen.t]

hallo, Ich habe mich auf das Forum, weil ich habe ein Problem mit Saeco Wien, wenn die Bewegung, um Kaffee der Motor läuft sehr langsam befreien von Mäusen mir sagen, was falsch ist? sorry, aber die Übersetzung Ich bin mit dem Übersetzer von Google

 

[Saeco-Bastler]

Hi vincen.t !

Please write again question in English !

Do you think that the geared motor is running slow?

It is very difficult to understand !

 

[hmilbradt]

Hi,

If the motion of the brew unit is to slow, usually the voltage regulation has encountered a break down. Measure the voltages at the motor connector JP8 between both yellow cables and between the red/blue cables. The target voltages are 80 VDC and 33 VDC. Next, pull the plug and measure the resistance between those cables. Target resistance ca. 130 Ohm and 25 Ohm. Upload the values.
The slow motion is usually caused by a defective power transistor BD 245C/TIP 33C (position at the cooling unit) and/or a defective Zenerdiode ZD 33 V (1.3 Watts).
The link shows a diagramm of the ..... voltage regulator

regards
Harry

 

[vincen.t]

Hi,

If the motion of the brew unit is to slow, usually the voltage regulation has encountered a break down. Measure the voltages at the motor connector JP8 between both yellow cables and between the red/blue cables. The target voltages are 80 VDC and 33 VDC. Next, pull the plug and measure the resistance between those cables. Target resistance ca. 130 Ohm and 25 Ohm. Upload the values.
The slow motion is usually caused by a defective power transistor BD 245C/TIP 33C (position at the cooling unit) and/or a defective Zenerdiode ZD 33 V (1.3 Watts).
The link shows a diagramm of the ..... voltage regulator

regards
Harry

Leider wieder für die Übersetzung, aber dank der Unterstützung Ihrer wunderbaren Forum habe ich repariert die Kaffeemaschine mit nur 6 Euro
Ich kaufte den Transistor TIP33C und ZENNER
Vielen Dank noch einmal an alle!