Where can I buy SM8889/00 parts that ship to the US?

[billheav]

Hello everyone, does anyone know where I can buy parts for my SM8889/00 that ships to the US? Somewhere on this site I found an old list of Saeco supplier from 2007 and I found this vendor and it appears they ship to the US, is anyone familiar with this vendor? https://www.ersatzteileshop24.at/kaffeemaschine-ersatzteile.html Thanks for reading

 

[Grisu]

I dont know this shop here in Vienna, website seems to be ok and no fake, but reviews are really bad, if something wents wrong.

ersatzteileshop24 wird auf Trustpilot mit 1,9 von 5 als „Mangelhaft“ bewertet

Finden Sie, dass der TrustScore von ersatzteileshop24 passt? Berichten Sie von Ihren Erfahrungen und lesen Sie die Bewertungen von 82 Kunden.

at.trustpilot.com

 

[Papaya87]

https://encompass.com/ ?

 

[billheav]

https://encompass.com/ ?

They only sell for US models, thanks for replying.

 

[billheav]

I don't know this shop here in Vienna, website seems to be ok and no fake, but reviews are really bad, if something went wrong.

https://at.trustpilot.com/review/www.satzteileshop24.at

Thanks for your reply, as it turns out they do not ship to to the US. I just received my inquiry from them, thanks again for your help

 

[Advocat]

where I can buy parts for my SM8889/00 that ships to the US?

Which parts exactly do you need for your SM8889/00? Many parts are universal and you may be able to purchase them directly from you.

 

[billheav]

Which parts exactly do you need for your SM8889/00? Many parts are universal and you may be able to purchase them directly from you.

Please don't laugh but I don't know yet. You're right I did a little more research and I did find some parts available in the US. Here is my situation, I made an earlier post on the Xelsis SM section: https://saeco-support-forum.de/threads/sm8889-00-repair.65393/ I'm trying to determine if I should accept Saeco/US offer or should I keep my SM8889/00 and repair myself. Part availability is crucial of course and I'm trying to make the right decision.
Thanks for your reply and if you have any further recommendations it would be appreciated.

 

[Advocat]

First decalcificate with an amidosulfonic acid decalcifier. Than completely disassemble the brew group and clean it thoroughly. Replace all seals in the brew group and water inlet paths. And if problems persist, consider the “downgrade” offer from Saeco/US.

 

[billheav]

Thank you for the advice, I'll give it a try.

 

[billheav]

Thank you for the advice, I'll give it a try.

I just ordered Durgol, it contains the chemical you suggested and I've also seen it recommended on the forum, that it's better than the Saeco/Phillips descaler. Are there any special instructions that you may recommend that's not written on the bottle?
It's so frustrating, one shot will be fine, the next shot nothing, and sometimes something in between. After reading through the forums I'm thinking either the flow selector (also known as turbine) or maybe the pump, both parts I can purchase from US vendors. On the other hand it is possible it could be the main control board eg cold solder joint, something that is not available in the US? (I know, I'm a too negative thinker )
Again, thank you for your help and advice, also a shoutout to Watchmaker, another expert on the forum.