lifeisfun
Kaffeetrinker
- Dabei seit
- 01.11.2022
- Beiträge
- 78
Hi folks!
New here, and I hope someone can give me some pointers what else could be wrong.
Tried to fix the typical saeco cracked spring that holds the brushes and no longer making connection.
Done that without problems in the past on several machines, but this time this is not the only problem.
The grinder motor will still not operate ( test mode)on the Xprelia.
Also did quick Triac check ( did not remove them from the board for the test)
The ceramic 2.2 ohm resistor is ok, and both black coils are also OK.
Also tested with another motor.
There is steady 41V DC on the grinder terminals no matter what.
Any ideas please?
Thank you!
New here, and I hope someone can give me some pointers what else could be wrong.
Tried to fix the typical saeco cracked spring that holds the brushes and no longer making connection.
Done that without problems in the past on several machines, but this time this is not the only problem.
The grinder motor will still not operate ( test mode)on the Xprelia.
Also did quick Triac check ( did not remove them from the board for the test)
The ceramic 2.2 ohm resistor is ok, and both black coils are also OK.
Also tested with another motor.
There is steady 41V DC on the grinder terminals no matter what.
Any ideas please?
Thank you!